Section 8. Troubleshooting; Using The Information Led For Troubleshooting (9350 / P935 Cleaner); Viewing Cleaner Status Information For Troubleshooting (9450 Sport/P945 And 9550 Sport/P955) - Polaris 9350 Sport Manuel Du Propriétaire

Section 8. Troubleshooting

8.1

Using the Information LED for Troubleshooting (9350 / P935 Cleaner)

The Information LED
cleaner malfunctions.
Information LED Flashing
LED flashes once with one second
interval.
LED flashes twice with one second
interval
LED flashes three times with one
second interval
8.2 Viewing Cleaner Status Information for Troubleshooting (9450 Sport/P945 and 9550
Sport/P955)
Information about your cleaner's current status and any relevent error condition is available through a
troubleshooting status screen. To view this information:
1. Remove cleaner from the pool and turn power off.
2. Press
and
The following cleaner operation messages are displayed consecutively for three (3) seconds:
After cycling through each message, control unit returns to current day and time display.
on the control unit flashes in a specific sequence to indicate one of three possible
Unplug the floating cable from the control unit and reconnect.
If the problem is not resolved through troubleshooting, first contact your
local retailer to request a diagnostic review, or contact
Polaris Technical Support at (USA) 1-800-822-7933.
Turn cleaner wheels to ensure they are not jammed.
Check brushes for debris.
Start a new cleaning cycle.
If the problem is not resolved through troubleshooting, first contact your
local retailer to request a diagnostic review, or contact Polaris Technical
Support at (USA) 1-800-822-7933.
Check the pump axis for debris.
Check propellor for debris.
Clean the filter.
Start a new cleaning cycle.
If the problem is not resolved through troubleshooting, first contact your
local retailer to request a diagnostic review, or contact Polaris Technical
Support at (USA) 1-800-822-7933.
at the same time and hold for at least five (5) seconds.
Total hours cleaner has operated since new.
Last error code (if cleaner has had at least one error).
Time (in operating hours) the error occurred.
Solution
Page 21