EN
5.3.3
Setting the operating mode
The product is factory-set to the operating mode "Eco". If you want to
operate the product in the operating mode "FailSafe", you must change
the position of the jumper on the PCB.
Verify that the mains voltage is interrupted and cannot be switched on.
1. Open the control unit.
2. Plug the jumper onto the contacts for the operating mode to be set.
Fig 6: Setting the operating mode
3. Close the control unit.
20
Minimelder-R / Maximelder-R
Mounting
A
B
A. Eco
B. Failsafe