Network Settings; Led In The Upper Part Of The Housing; Dip Switches (Terminating Resistor); Spare Parts - Resol VBus/CANopen Manuel

4

Network settings

In order to setup the interface adapter in the network, the
configuration file must be loaded.
Î Insert the MicroSD card into the slot.
While the configuration file is being loaded, the LED flashes
green quickly.
When the process has been completed, the LED flashes
green slowly. The process may take up to 30 s.
Afterwards, the interface adapter is ready for operation.
5

LED in the upper part of the housing

The bi-coloured LED indicates the operating status of the
interface adapter:
LED flashes green slowly:
Everything OK
LED flashes green quickly:
Configuration file is being loaded
LED glows permanently blue:
Initialisation error
6

DIP switches (terminating resistor)

The interface adapter is equipped with 2 DIP switches
by means of which the position of the adapter inside the
CANopen network can be adjusted.
The following DIP switch positions are possible:
Both DIP switches in upper position:
The interface adapter is connected to the end of a CAN-
open network.
Both DIP switches in lower position (factory setting):
The interface adapter is not connected to the end of a
CANopen network.
7

Spare parts

VBus
®
Article no.: 112 091 98
Mains adapter 5V DC/2.1A
Article no.: 11213883
cable
15