Resol VBus/CANopen Manuel page 14

The VBus ® cable can be extended or replaced with a two-
wire cable (minimum cross section: 0.5 mm
can be extended up to 50 m in the case that one module
is used.
ATTENTION! Routing extra-low voltage cables together
in a cable conduit with cables carrying a
voltage higher than 50 V can lead to dam-
age to the device.
Î Always route extra-low voltage cables
and mains cables separately!
Î Pay attention to the local regulations!
Î To close the housing again, relocate the upper part of
the housing and refasten the cover screw.
Î Establish the CANopen connection (3-wire cable not
included).
Î Establish the mains connection by means of the mains
adapter included.
14
Interior view of the VBus
). The bus cable
2
DIP switches
(terminating resistor)
/ CANopen interface adapter.
®
Mains connector
MicroSD card
Bi-coloured
LED
H/GND/L
VBus
CANopen terminals
terminals
®