Technical Data; Mounting - Resol VBus/CANopen Manuel

1

Technical data

Housing: plastic
Ingress protection: IP 20 (EN 60529)
Protection class: III
Ambient temperature: 0 ... 40 °C
Dimensions: 95 × 70 × 25 mm
Mounting: wall mounting (optional)
Display: 1 bi-coloured LED in the upper part of the
housing
Data interface: RESOL VBus
MicroSD card slot
Power supply:
mains adapter: 100 – 240 V~, 1A / 5 V ⎓ , 2.1 A (Level 6)
interface adapter: 5 V ⎓ / 2.1 A 5.5 × 2.1 mm
electrical energy source: ES1 (EN 62368-1)
electrical power source: PS1 (EN 62368-1)
thermal energy source: TS1 (EN 62368-1)
mechanical energy source: MS1 (EN 62368-1)
VBus ® /CANopen
Made in Germany
Input: 5V / 2,1 A
-
+
5.5 x 2.1 mm
Use mains adapter in Mains adapter protec-
dry interior rooms tion class: II
only.
12
, CANopen interface,
®
Coaxial connector
polarity:
Internal: Plus
External: Minus (GND)
2

Mounting

The device must only be located in dry interior rooms.
The interface adapter is light and small enough to not re-
quire any form of mounting. It can be placed directly on
the desk or on a system component (pay attention to the
allowed ambient temperature!).
4 self-adhesive, skid-proof rubber pads are included with
the device. If necessary, these can be affixed to the corre-
sponding molds on the base part of the housing to ensure
a secure placement of the device without wall mounting.
If desired, the device can be mounted to a wall. To do so,
proceed as follows:
Î Mark the desired position on the wall.
Î Drill and prepare the hole with a wall plug and screw.
Î Hang the housing from the upper fastening point and
mark the lower fastening point (centres 70 mm).
Î Insert lower wall plug.
Î Fasten the housing to the wall with the lower fasten-
ing screw and tighten.