Husqvarna 582559701 Mode D'emploi page 5

Bagger Mount
1. Install the bagger mount tube (A) to the rear
guard with 5/16-18 x 3-1/4 bolts and flange
nuts from kit.
2. Install the kit support straps (B) on the
outside of the mount tube. Attach the front
side of the strap to the fender support with a
5/16-18 x 1-1/4 bolt, inserting a spacer (C)
between the mower and the strap. Do not
add the flange nut at this time.
3. Put the reinforcement plate (D) to the
outside of the fender support. Attach with an
additional 1-1/4 bolt and fasten both bolts
with flange nuts. Repeat steps on opposite
side.
NOTE: The front side of the kit support straps
should be on the inside of the mower frame.
4. Tighten all hardware.
D
B
A
ASSEMBLY
C
B
Mounting Cover Assembly
NOTE: Assistance from another person may
ease mounting the cover assembly to mower.
1. Lift and rotate the cover to align the cover
brackets with the support assembly tubes.
2. Move the cover down over the support tubes.
Container Assembly
1. Install the containers on the support frame,
overlapping containers at the center
supports.
2. Close the cover and lock the latch handles
over the center support tubes.
5 5