Vollrath FC-6IH-01120 Manuel De L'opérateur page 9

TROUBLESHOOTING (CONTINUED)
Display Message Might be Caused By
There is not a pan(s) over the
induction capsule(s).
The induction capsule(s) may not be
adjusted to fit the pan.
Power level or
The pan is not a Vollrath induction-
temperature is flashing.
ready pan.
The induction capsule(s) may be
tilted and therefore preventing
adequate contact with the pan.
The pan is not a Vollrath induction-
ready pan.
The induction capsule(s) may be
tilted and therefore preventing
BAD PAN
adequate contact with the pan.
The induction capsule(s) may not be
adjusted to fit the pan.
If the equipment is in use, the pan
HOT
may be too hot.
F-2 The pan may be too hot.
The equipment may have overheated. Relocate the equipment away from external heat sources. Clear any obstructions
F-1
The equipment may have overheated. Specified installation clearances could be violated, reinstall following specified
F-8
Trouble with the electrical
connection.
F-14
The supply voltage is incorrect for the
equipment.
A USB cable is disconnected or is not
being recognized.
—
A problem with the control panel.
Other error codes Internal error.
Modular Induction Dry Well Drop-ins Operator's Manual
Course of Action
Place a Vollrath induction-ready steam table pan over the induction capsule(s).
Set the induction capsule risers to the correct position to match the pan(s). See
"Adjust the Induction Capsules to Accommodate the Pan(s)" on page 3.
Replace the pan with an Vollrath induction-ready pan. For information about
Vollrath induction-ready pans see "Insert Pans of Prepared Hot Food" on page 3.
Inspect the induction capsule(s). Reposition if one or both are tilted in the well.
Replace the pan with an Vollrath induction-ready pan. For information about
Vollrath induction-ready pans see "Insert Pans of Prepared Hot Food" on page 3.
Inspect the induction capsule(s). Reposition if one or both are tilted in the well.
Adjust the capsule(s) to fit the pan. See "Adjust the Induction Capsules to
Accommodate the Pan(s)" on page 3.
Remove the pan. Allow the pan and equipment to cool before resuming use. Do
not place excessively hot food into the pan. Do not an place an excessively hot pan
into the equipment. Contact Vollrath Technical Services if the problem persists.
to the air intake. Contact Vollrath Technical Services if the problem persists.
clearances. Refer to the specification sheet on Vollrath.com.
Make sure the plug is fully inserted into an electrical outlet that matches the rating
on the equipment's nameplate.
Make sure the electrical circuit is not overloaded.
Plug the equipment into an outlet with the correct voltage.
Check the connections on the back of the control to verify the USB cables are
connected. If the problem continues, contact Vollrath Technical Services.
Contact Vollrath Technical Services.
Contact Vollrath Technical Services.
9