Helo Digi I Manuel Produit page 27

Installation and User Manual
Mount and program the control panel
The control panel has several holes in the back. These holes are used to mount the
control panel outside the sauna. In order to reach the holes, the control panel must be
opened using the two keys that are included. The control panel can be mounted in or on
the wall. When the control panel is installed and the lid is replaced you have to set a
number of basic settings on the display. The basic settings include among other things to
set the time and chose the language.
prog ok
1. Mark on the wall where the
control panel should sit
2. Use the control panel opener to
open the lid.
3. Set the sheet-metal screws,
4,2 x 13 mm, in the holes and
screw the control panel in place.
4. Lead the cable through the
control panel so that it is placed
right before the lid is put back on.
5. Put the lid back on and set the
basic settings.
Digi 1
Open the lid of the control panel by
inserting the control panel openers on
the side.
8