Helo Digi I Manuel Produit page 25

Installation and User Manual
FUNCTION:
1. Start Start operation by pressing ON_OFF.
The display will show 00:00. The indicator lights will not come on.
2. Preset time Press the Preset time button.
00:00 will appear in the display (The preset time is not stored in the permanent memory; it is
selected for each sauna run time).
The corresponding indicator light starts blinking and the setting can be made using the arrow
buttons.
Press OK to accept the setting and store it in memory.
The indicator light will remain lit.
3. Heating time Press the Heating time button.
The last programmed time will appear in the display (factory setting 02:00).
The corresponding indicator light will start blinking and the setting can be made using the arrow
buttons.
Press OK to accept the setting and store it in the operating and permanent
EEPROM memory. The corresponding indicator light will remain lit.
4. Temperature Press the Temperature button.
The last programmed temperature will appear in the display (factory setting 80°C).
The corresponding indicator light will start blinking and the setting can be made using the arrow
buttons.
Press OK to accept the setting and store it in the operating and permanent
EEPROM memory. The corresponding indicator light will remain lit.
NOTE The unit will remain in program mode until OK is pressed down for 3 seconds.
After making your desired settings, you can browse through them by pressing the setting button
for each value.
If you want to use the settings from the previous sauna run, skip steps 3 and 4 and go
directly to step 5.
5. Start Press OK for 3 seconds to start operation.
The heating time will appear in the display for 5 seconds, after which the sauna room
temperature will appear and the temperature indicator light will come on.
Quick functions When starting controller operation as in step 1, you can select the quick function by pressing
OK for 3 seconds.
The sauna will immediately begin heating up and the heating time will appear in the display for
5 seconds, after which the sauna room temperature will appear and the temperature indicator
light will come on.
The factory set sauna run time is 2 h and temperature setting 80°C.
You can change or check settings as in previous steps.
Digi 1
6