Iso-Tech IIT 1500 Manuel D'utilisation page 4

SECTION 1 - SAFETY INFORMATION
Safety Information
Read and understand this instruction manual completely before using this
instrument. Failure to observe the warnings and cautions in this instruction
manual may result in injury, death or damage to the instrument and other
equipment or property.
If this instrument is used in a manner not specified in these instructions,
the protection provided by the instrument may be impaired.
Warning
Identifies hazardous conditions and actions that could cause BODILY HARM
or DEATH.
Caution
Identifies conditions and actions that could DAMAGE the tester or equipment
under test.
WARNING
• Examine the instrument and probes before use. Do not use the instrument if
it is wet or damaged
• When using test leads or probes, keep your fingers behind the
finger guards
• Remove test leads from instrument before opening the battery door or
instrument case
• Use the instrument only as specified in this manual or the protection by the
instrument might be impaired
• Always use proper terminals, switch position, and range
for measurements
• Verify the instrument is operating correctly by measuring a known voltage
before use. If in doubt, have the instrument calibrated
• Do not apply more than the rated voltage, as marked on instrument, between
terminals or between any terminal and earth ground
• Only replace the blown fuse with the correct type and rating as specified in
this manual
• Use caution with voltages above 30 Vac rms, 42 Vac peak , or 60 Vdc. These
voltages pose a shock hazard
• To avoid false readings that can lead to electric shock and injury, replace
battery as soon as low battery indicator "<" appears
• Disconnect circuit power and discharge all high-voltage capacitors before
making resistance measurements
• Do not use the instrument in hazardous areas or around explosive gases or
vapours
• Wear suitable personal protective equipment when working around or near
hazardous live conductors which could be accessible.
IIT 1500 English
3