1. Remove the door trim by loosening the 2 Torx screws
attaching it to the range. Slide the trim up and off the
screws.
2. To remove the pallet bolts use (2) ½" (13 mm)
wrenches, one to hold bolt at the bottom while the other
is loosening the nut at the top. Discard the wood
packing block inserts.
Figure 7: Removal of Shipping Bolts
English 10
Figure 6: Door Trim Removal
3. Carefully tilt the range back and remove it from the
pallet. Use additional help as required to remove from
pallet.
4. After transporting the range by dolly close to its final
location, the range can then be tipped back while the
dolly is carefully removed.
5. THE FLOOR UNDER THE LEGS SHOULD BE
PROTECTED BEFORE PUSHING THE UNIT INTO
POSITION.
•
Steps 5 through 8 must be completed before the
range is placed in its final position.