DeWalt DW0165 Manuel D'utilisation page 21

Select as the measurement type.
a
4.
a
• Press to display the Main Menu
(Figure ).
E 2
• Press to select
• Press to display the Measurement
Type Menu (Figure
• Press the arrow buttons to select
(Figure ).
E 4
• Press .
Determine the distance between each
5.
stud, for example, 12".
Press and until the top number on
6.
the screen is set to the distance from the
right edge of one stud to the left edge of
the next (e.g., 12") (Figure
Line up the back of the tool with the right
7.
edge of the last stud that is nailed in
(Figure ).
U 2
Press to start measuring the
8.
distance as you slowly move the tool to the
right.
Continue moving the tool to the right until
9.
the bottom number on the screen is 0.00 in
(Figure ).
U 3
Press to stop measuring.
10.
Using a pencil, mark the location where the
11.
left edge of the stud should be nailed into
the wall frame.
Nail the left edge of the stud at the marked
12.
location.
For each remaining stud in the wall frame,
13.
repeat steps 7-12 (Figure
.
).
E 3
a
a
).
U 1
).
U 4
Measuring an Angle
If you need to determine the angle at which
something is positioned, use the tool to
measure that angle (Figure
Point the tool's laser (Figure
1.
a wall or object, and not toward anyone's
eyes.
Press (Figure
2.
on and display the red laser dot.
Make sure the tool position setting
3.
(Figure ) is correct for taking the
C 4
measurement.
Select as the measurement type.
4.
• Press to display the Main Menu
(Figure ).
E 2
• Press to select
• Press to display the Measurement
Type Menu (Figure
• Press the arrow buttons to select
• Press .
Position the tool at the angle to be
5.
measured (Figure
Press to take the measurement.
6.
View the angle measurement on the
7.
screen (Figure
W 2
Using the Tool as a Level
Point the tool's laser (Figure
1.
a wall or object, and not toward anyone's
eyes.
Press (Figure
2.
on and display the red laser dot.
).
W
) toward
A 1
) to turn the tool
A 3
.
).
E 3
.
).
W 1
).
) toward
A 1
) to turn the tool
A 3
E
21