Battery Safety - DeWalt DW0165 Manuel D'utilisation

Masquer les pouces Voir aussi pour DW0165:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FCC Statement
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. This device is a portable unit.
The exclusion threshold is 0.887<3. However,
there is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the
equipment and the receiver.
- Connect the equipment into an outlet on
a different circuit (not the circuit to which the
receiver is connected).
- Consult the dealer or an experienced radio/
TV technician for help.
Canada, Industry Canada (IC) Notices
Class B digital circuitry of this device complies
with Canadian ICES-003. This device complies
with Industry Canada license-exempt RSS
standard(s). Operation is subject to the
following two conditions: (1) this device may
not cause interference, and (2) this device
must accept any interference, including
interference that may cause undesired
operation of the device.
Under Industry Canada regulations, the radio
transmitter(s) in this device may only operate
using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio
interference to other users, the antenna type
and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.)
is not more than that necessary for successful
communication.

Battery Safety

WARNING: Batteries can explode or
leak and cause serious injury or fire. To
reduce the risk:
ALWAYS follow all instructions and
warnings on the battery label and
package.
DO NOT short any battery terminals.
DO NOT charge alkaline batteries.
DO NOT mix old and new batteries.
Replace all of them at the same time
with new batteries of the same brand
and type.
DO NOT mix battery chemistries.
DO NOT dispose of batteries in fire.
ALWAYS keep batteries out of reach
of children.
ALWAYS remove batteries if the
device will not be used for several
months.
NOTE: Ensure that the recommended
batteries are used.
NOTE: Ensure the batteries are
inserted in the correct manner, with the
correct polarity.
E
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dw0165sDw0330s

Table des Matières