Panasonic MK-F800 Instructions De Fonctionnement page 9

PART NAMES
Blender, Dry Mill & Accessories

Working
capacity: 1 L


1. Blender Lid
2. Blender Jug
3. Blender Cutting Blade
4. Mill Container
5. Mill Cutting Blade
Control Panel
Mode Selection
- Auto Menu -
Mince Mode
Chop Mode
Frozen Mode
Paste Mode
Drainer Mode
- Manual Menu -
Continuous Mode
Intermittent Mode
Note:
• The program will time-out and reset itself after 10 seconds if no further action is done after a function is
selected.
• Turning the Rotary Dial clockwise will increase the number of lighted bars and vice versa.
• The default speed for the Continuous and Intermittent modes are at maximum, (level 10).
• The program will time-out and reset itself after 20 seconds if the program is paused during processing and no
further action is done.
• Continuous Mode will stop automatically approximately 19 minutes and Intermittent Mode will stop
automatically approximately 7 minutes after processing is started.
100_160419_MK-F800_Second_EU(UZ50E153).indb



PULSE Switch
Speed and Timer/Driving Time indication L.E.D.
: Light up when Manual Menu is operating and indicate speed level by bars.
: Light up when Auto Menu is processing and indicate Timer/Driving time by bars.
9


6. Mill Container Base
7. Storage Case Unit
8. Brush
Mode Indication L.E.D.
Stop/Start Switch
For Auto Menu: to Pause/Start process
For Manual Menu: to Stop/Start process
Rotary Dial
Adjusst Speed and Timer/Driving Time
GB9
2016/04/19 16:56:45