Panasonic MK-F800 Instructions De Fonctionnement page 15

FOOD PROCESSOR
Operating with Auto Menu
1
After completing the assembly steps, plug-in the plug
into the socket and turn on the Power Switch. The Mode
Indication L.E.D.s will light up and blink.
3
Each Auto Menu has a pre-programmed driving time.
Each lighted bar represents 10 seconds* of driving time.
Push the Stop/Start Switch to start the operation.
5
After the processing is completed, switch off the Power
Switch and unplug from the socket.
* For Paste Auto Menu, each lighted bar represents 1 minute. The lighted bar will decrease at every 1 minute
interval.
Note:
• Always ensure that the Knife Blade is inserted before adding ingredients into the Bowl.
• The Driving Time of the Auto Menu can be increased or decreased by adjusting the Rotary Dial if necessary.
• The operation of the Auto Menu can be stopped prematurely by pushing the Stop/Start Switch before the set
duration ends.
• Depending on the speed and amount of ingredients used, there will be significant vibrations present. In that
case, hold down the Bowl Lid with both hands to support it during its operation.
100_160419_MK-F800_Second_EU(UZ50E153).indb
-KNIFE BLADE-




15
2
Select the required Auto Menu mode (except the
Drainer Mode). The selected Mode Indication L.E.D. will
light up and a beep sound will be heard. The Driving
Time and Stop/Start Switch Indication L.E.D. will light up
and blink.
4
During operation, the Driving Time L.E.D. will turn off
one by one after every 10 second intervals until the set
duration is completed and 4 beep sounds will be heard.
The Mode Indication L.E.D.s will light up and blink.
6
Remove the Knife Blade from the Bowl before removing
the processed ingredients.
GB15
2016/04/19 16:56:47