Getting Started; Fitting The Remote Controller Batteries; Clock Settings; Operating Instructions - Saunier Duval SDH 18-025 NW Mode D'emploi

Unités murales
Masquer les pouces Voir aussi pour SDH 18-025 NW:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 88

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS
6

Getting started

6.1

Fitting the Remote Controller Batteries

Insert two batteries (2 No. size AAA), as described below (see
Figure 6.1).
1
Fig. 6.1
Fitting the remote controller batteries.
Legend
1
Battery lid
2
Batteries
A
Pressure area for opening the lid
EN
B
Battery compartment
• Remove the battery lid by pressing gently on zone A and
pushing the lid downwards.
• Insert the batteries in the remote control ensuring correct positive
and negative polarity (Shown on the battery compartment).
• Put the lid back on.
• Press the ON/OFF button (see Figure 7.1) to check that the
batteries are correctly inserted.
- 8 -
A
B
2
1
NOTE:
i
If nothing appears on the display after pressing ON/
OFF, refit or replace the batteries.
Always replace both batteries at the same time.
NOTE:
i
If the remote controller does not work correctly during
operation, please remove the batteries and reposition
after a few minutes.
If the unit is going to be out of use for a long period
remove the batteries. If there is anything still showing in
display, just press the reset button.
ATTENTION:
b
Danger of the enviromental contamination by not
disposing of the batteries properly.
When replacing the remote controller batteries, dispose
of batteries in the correct manner.
Never throw away in the rubbish.
6.2

Clock Settings

Use the remote controller buttons to adjust the unit clock the first time
the unit is started or after replacing the batteries, see Figure 6.2.
• Press the CLOCK button once.
The hour indicator start to flash on the remote controller display.
• Press the + / - buttons to set the desired time:
When pressing the + / - buttons, the time configuration will
increase or decrease by 1 minute.
If the + / - buttons are kept pressed, the time will increase or
decrease rapidly.
• Press the CLOCK button once.
The hour indicator will stop flashing and the clock will start to
operate.
SDH18-NW-U_EN - 05/14 - Saunier Duval

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sdh 18-035 nwSdh 18-050 nw

Table des Matières