Schick Dental S2 Master Mode D'emploi page 29

12
17
pict. 1
pict. 2
pict. 3
milling spindle
14 To remove the milling spindle detach light equipment and loosen knurled nut
(14) (pull spindle out upwards). To detach the light equipment loosen knurled
nut (15) (pict.1) and pull light equipment carefully down.
15
Put light equipment on again in reverse order.
When replacing the milling spindle pull down until stop.
Pleas
e pay attention that the thread pin placed in the spindle
holder clicks into the notch at the milling spindle.
The lever (7) (pict.2) at the milling spindle has to show into the left
direction. Tighten knurled nut (14).
Function of milling spindle see see on page 11.
Height adjustment
12
To adjust the height of the milling arm fist loosen the lever (12).
13
Then using the adjusting knob (13) to put the milling arm up or down
pict. 1
according to your needs.
7
measuring spindle
The measuring spindle (pict. 3) is supplied as accessory and can be placed
into the spindle holder in the same way as the milling spindle.
10
Operation