Operation; Milling Arm/Jointed Arm - Schick Dental S2 Master Mode D'emploi

7. Operation

To activate the electric press mains switch (18) „I/O".
Now all electric functions are controllable. To switch the unit off press mains switch (18) again.

7.1 milling arm/jointed arm

15
16
pict. 1
8
pict. 2
31
12
pict. 3
13
The milling- and the jointed arm has 2 joints for an absolutely free moving space.
To fix the milling arm on the horizontal plane you can use the levers (6+9),
9
therefore it is possible to make bores and to fix.
6
For a delicate vertical movement of the spindle with fixed hinges loosen the
knurled nut (10) and use the lever (8). With the vernier (11) the maximum travel to
10
depth can be restricted. This assures exact guidance when drilling Interlooks.
9
8
10
38
11
If, for example, the milling spindle should be fixed in a deep position when
fixing a part of an attachment, the milling arm has to be moved downwards
(see pict. 3) at the spring mounted the guide bar. Then the position can be fixed
with the knurled screw (10).
9
Operation