Returning For Service - DeFelsko PosiTector 6000 Notice D'instruction

Before returning the instrument for service...
1. Install new or newly recharged batteries in the proper
alignment as shown within battery compartment.
2. Examine the probe tip for dirt or damage. The probe should
move up and down freely.
3. Perform a Hard Reset (pg. 6).
4. Place a plastic shim onto bare metal (steel or non-ferrous
metal, depending upon whether you have an "F " or "N" probe)
and attempt a measurement. (see Verification, pg. 3)
5. If issue is not resolved, Update (pg. 12) your PosiTector
gage body and re-attempt measurements.
IMPORTANT:
If these steps do not resolve the issue and the Gage must be
returned for service, please follow the instructions provided at
www.defelsko.com/service.
Limited Warranty, Sole Remedy
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on
its website: www.defelsko.com/terms
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted,
in whole or part, by any means, without written permission from DeFelsko Corporation.
DeFelsko, PosiSoft, and PosiTector are trademarks of DeFelsko Corporation registered in
the U.S. and in other countries. Other brand or product names are trademarks or registered
trademarks of their respective holders.
Every effort has been made to ensure that the information in this manual is accurate.
DeFelsko is not responsible for printing or clerical errors.

Returning for Service

and Limited Liability
www.defelsko.com
© 2020 DeFelsko Corporation USA All Rights Reserved