Returning For Service - DeFelsko PosiTector DPM Guide D'utilisation

Dew point meter

Masquer les pouces Voir aussi pour PosiTector DPM:

Table des Matières

Les langues disponibles

Before returning the instrument for service...

1. Install new batteries in the proper alignment as shown within battery

compartment.

2. Examine the surface temperature sensor for dirt or damage.

3. If the humidity sensor is slow to respond or reading erratically, recondition

the sensor by removing the probe from the gage body and wrapping it in

a damp cloth overnight.

4. Perform a Hard Reset. (see pg. 4)

5. If issue is not resolved, Update (pg. 10) your PosiTector gage body and

re-attempt measurements.

IMPORTANT:

If you must return the Gage for service, please fill out and include the

Service Form located at www.defelsko.com/support with the Gage. Be

sure to also include the probe, your company name, company contact,

telephone number and fax number or email address.

Limited Warranty, Sole Remedy

DeFelsko's sole warranty, remedy, and liability are the express

limited warranty, remedy, and limited liability that are set forth on

its website: www.defelsko.com/terms

or part, by any means, without written permission from DeFelsko Corporation.

DeFelsko, PosiTector and PosiSoft are trademarks of DeFelsko Corporation registered in the U.S. and

in other countries. Other brand or product names are trademarks or registered trademarks of their

respective holders.

Every effort has been made to ensure that the information in this manual is accurate. DeFelsko is not

responsible for printing or clerical errors.

Returning for Service

and Limited Liability

www.defelsko.com

Table des Matières