Laserworld Purelight Série Mode D'emploi page 13

Manual: Laserworld Purelight Series
b) Stand-Alone Mode / Automatic Mode / Playback Mode
Dip switch setting
switch 1
On (1) / Off (0) 0
In stand-alone mode the ILDA files on the integrated SD card are triggered automatically.
This setting is especially suitable for demo purposes or for fixed laser installations.
The stand alone mode allows for additional advanced features: As standard, the stand
alone mode cycles through the ILDA files on the SD cards and plays the consecutively
and in a general loop.
If DIP switch 4 is activated too, the stand alone mode only plays one specific ILDA file and
just loops this file.
switch 1
On (1) / Off (0) 0
Dip switch 1 can be used to step to the next file (just switch DIP switch 1 to on, then to
off again)
Dip switch 2 can be used to step to the previous file (just switch DIP switch 2 to on, then
to off again)
c) Demo Mode / Automatic Animation
switch 1
On (1) / Off (0) 0
In demo mode the ILDA files on the integrated SD card are triggered automatically. The
ILDA files are not only played back like in the stand alone mode, but they are also auto-
matically animated by ShowNET's internal intelligence. This creates dynamic animations,
even if only static frames are on the SD card.
This setting is especially suitable for demo purposes.
d) Sound-to-Light Mode / Music Mode
switch 1
On (1) / Off (0) 0
In sound-to-light mode, the ILDA files on the integrated SD card are triggered by the beat
of the music. The sensitivity of the microphone can be adjusted withe the trim pot at the
back side of the device marked „Sens".
page 13 / 69
2 3 4
0 0 0
2 3 4
0 0 1
2 3 4
0 0 0
2 3 4
0 0 0
5 6 7
0 1 0
5 6 7
0 1 0
5 6 7
1 0 0
5 6 7
0 0 1
English
8 9 10
1 0 0
8 9 10
1 0 0
8 9 10
0 1 0
8 9 10
0 1 0