Hiltron security TM Serie Manuel D'utilisation page 29

security
4.2 Enabling / disabling by the front panel key switch
4.2.1 Enabling
Verify that the zone status LEDs
If they're switched on it's necessary to close the doors and windows relative to the zone
signalled opened. It's also possible that the zone signalled opened could be the one
relative to the volumetric detectors; in this case the exiting time will allow to exit the
protected area without activating the alarm.
Turn the key switch
The green LED "EXIT"
protected areas.
When the exiting time is finished, the green LED "EXIT"
system is enabled.
4.2.2 Disabling
Open the entering door.
The yellow LED "ALARM"
entering door is usually protected by the delayed zone 1: the entering time will allows to
reach the central unit to disable the system.
Turn the key switch
The green LED "ALARM"
yellow LED "ALARM"
ALARM
LED
EXIT
LED
are turned off.
7
in the "ON" position.
1
starts blinking indicating the exiting time, in which to leave the
3
is lit. The alarm will not activates immediately becouse the
2
in the "ST/BY" position
1
3 turns off indicating that the system is disabled, while the
bilnking if the memory alarm is on.
2
System DISABLE
ON BLINKING
Alarm
memory:
see and
5
System Exiting
disable time
OFF ON
Entering
time
6
turns off indicating that the
3
System ENABLE
BLINKING OFF
Allarme
Mem. allarme
System
enable
Operating
29