Cleaning And Maintenance - Kalorik RVC 47730 BK Mode D'emploi

Directing to the Charging Base
If the vacuum has sufficient power, it can be directed to the charging base
by using the KALORIK Home app. Otherwise, the unit will return to the
charging base when low on power. Battery level is indicated by
percentage on the main screen, labeled "Residual Electricity".

CLEANING AND MAINTENANCE

Follow the instructions below regularly to clean and maintain the vacuum.
NOTE:
Before cleaning, always switch the vacuum off and disconnect the
‒
charging base.
Never immerse any electrical part of the product in water or other
‒
liquids. Never place under running water.
Never use solvents or abrasive materials. Never use metallic or
‒
sharp cleaning tools.
Cleaning the Filters
For optimal performance, cleaning the filters is recommended
approximately after a week of regular use.
Follow the instructions below along with the corresponding images.
Press down towards the end of the cover as indicated. The cover will
A.
open automatically.
After removing the dust container, please make sure to check if the
B.
suction channel of the appliance is not obstructed in any way.
Remove the HEPA filter.
C.
Remove the preliminary filter.
D.
Pour all the dust out of the dust container onto a trashcan.
E.
Proceed to clean the dust container, preliminary filter, and HEPA filter
F.
fully. Our suggestion is to clean the HEPA filter every 15-30 days of use.
The maximum service life of the HEPA filter is 24 months. The HEPA filter is
not to be cleaned using a brush, but instead it should be blown using a
dryer, or slightly knocked to remove all the dust. NOTE: Please do not
wash it with water.
Assemble all parts again carefully. Please make sure both filters are
G.
assembled properly to prevent any damage to the appliance.
www.KALORIK.com
12
RVC 47730 BK - 200605