Kalorik RVC 47730 BK Mode D'emploi page 14

Cleaning the Side Brushes
For optimal performance, cleaning the side brushes is recommended
approximately after a month of regular use. Follow the instructions below to
clean the side brushes.
• Remove the side brushes from the vacuum.
• Carefully remove any debris wrapped between the main unit and the
side brushes.
• Use a cloth dampened with warm water to remove any dust from the
brushes or to gently reshape them.
TROUBLESHOOTING
Status
The robot vacuum is on
standby mode or
working normally.
The robot vacuum is on
the base and the
battery is charged
Cleaning paused
The robot vacuum is on
the base and charging
Ion function is on
The robot vacuum is in
standby mode
Floor sensor error
Side brush error
Fan motor error
Abnormal collision
www.KALORIK.com
LED
Permanently blue
Permanently blue
Flashing blue
Flashing blue
Permanently purple
Light off
Red light is permanently
on while the robot
vacuum beeps once
Red light flashes while
the robot vacuum beeps
once
Red light permanently
on while the robot
vacuum beeps twice
Permanently red while
the robot vacuum beeps
3 times
14
Solution
N/A
N/A
N/A
N/A
N/A
N/A
One of the floor sensors
has been disrupted.
Check to see if the
robot vacuum is on an
abnormal surface and
reposition.
Check to see if the side
brushes are obstructed.
Check to see if there is
any obstruction to the
air suction.
Check the front
bumper for any
obstructions
RVC 47730 BK - 200605