Samsung FE-R400SX Manuel D'utilisation page 43

PROBLEM
Oven not clean after
a self-cleaning cycle
Steam from the vent When using the convection
Burning or oily odor
emitting from the
vent
Strong odor
Oven racks are
difficult to slide.
Display goes blank.
Display flashes.
Drawer does not
slide smoothly or
drags.
FE-R400_XAC_DG68-00297A-06_EN.indd 42
POSSIBLE CAUSE
The oven controls were not set
correctly.
The oven was heavily soiled.
feature, it is normal to see steam
coming out of the oven vent.
As the number of racks or amount
of food being cooked increases,
the amount of visible steam will
increase.
This is normal in a new oven and
will disappear in time.
An odor from the insulation around
the inside of the oven is normal
for the first few times the oven is
used.
The shiny, silver-colored racks
were cleaned in a self-cleaning
cycle.
A fuse in your home may be blown
or the circuit breaker tripped.
There was a power failure.
The drawer is out of alignment.
The drawer is over-loaded or the
load is unbalanced.
SOLUTION
• See the section on self-cleaning on page
31.
• Wipe up heavy spillovers before starting
the self-cleaning cycle. Heavily soiled
ovens may need to self-clean again or for
a longer period of time.
• This is normal.
• To speed the process, set a self-cleaning
cycle for a minimum of 3 hours.
• See the section on self-cleaning on page
31.
• This is temporary.
• Apply a small amount of vegetable oil to
a paper towel and wipe the edges of the
oven racks with the paper towel.
• Replace the fuse or reset the circuit
breaker.
• Reset the clock.
• Fully extend the drawer and push it all the
way in. See the page 38.
• Reduce weight. Redistribute drawer
contents.
Troubleshooting _42
2013-06-11 12:38:47