Maintenance/Troubleshooting And Service - Binks MAG II Mode D'installation

MAINTENANCE/TROUBLESHOOTING AND SERVICE

INSTRUCTIONS (CONTINUED)
REMOVING/REPLACING GUN
ASSEMBLY MODULE ONLY
FROM INLET MANIFOLD
ASSEMBLY
1. Using a 9/64" Allen wrench (supplied
with gun), turn retaining cap screw
(23) counter-clockwise typical
4 places and remove gun sub module.
2. Mount the new gun module, tightening
the retaining screws (23) "wrench tight".
This will allow fluid and air passages
to seal with no contamination.
O-rings (25 & 29) must be replaced
when replacing gun sub module.
MAG II AUTOMATIC HVLP HOSE HOOK-UPS
Hose Hook-Up with Atomizing/Fan Air COMBINED
GROUND
GROUND
Hose Hook-Up with Atomizing/Fan Air SEPARATED
(FOR FLAT TIP APPLICATIONS ONLY)
GROUND
GROUND
FLUID SUPPLY
FLUID SUPPLY
8
NOTE
FLUID RETURN
FLUID RETURN
ATOMIZING AIR
REGULATOR
ATOMIZING AIR
REGULATOR
CYLINDER
PLUG
AIR SOLENOID
CYLINDER
(3-WAY)
PLUG
AIR SOLENOID
(3-WAY)
FLUID SUPPLY
FLUID SUPPLY
FLUID RETURN
FLUID RETURN
ATOMIZING AIR
REGULATOR
ATOMIZING AIR
REGULATOR
CYLINDER
AIR SOLENOID
CYLINDER AIR
CYLINDER
(3-WAY)
AIR SOLENOID
CYLINDER AIR
(3-WAY)
FAN AIR
REGULATOR
FAN AIR
REGULATOR
MAG II AUTOMATIC HVLP
PISTON POSITIONING
Install piston assembly into piston
housing. Be sure all o-rings are
properly lubricated with 41-4458
PTFE-based lubricant provided
with o-ring repair kits.
Piston Assembly
Piston assembly must be
bottomed out in the piston
housing (approximately 5/8" from
the top of the piston housing).
Lift the collet until it stops and
hold in an upright position while
inserting a 5/16" wrench onto
the collet.
Collet Locknut
FILTER
FILTER
Insert and tighten the collet
locknut using a second 5/16"
wrench and "wrench tighten".
If properly assembled, bottom
FILTER
of collet should be 3/16" from
FILTER
the top of the piston assembly.
The gun will leak air if the piston is not
adjusted correctly.
Piston Assembly
Piston Housing
Collet
3/16"
NOTE