Element Cycling; Turn Product On/Off; Operating The Cooking Elements - GE Appliances JP3030 Manuel Du Propriétaire

Element Cycling

Surface elements will cycle on and off to maintain the
temperature you have selected. All radiant surface elements
have a temperature limiter that protects the glass cooktop
from getting too hot, this is normal. The temperature limiter
may cycle the elements off more frequently if:

Turn Product On/Off

setting you want. When the control is in any position
other than Off, it may be rotated without pushing it
down. You may feel a slight bump when it is rotated
through the Lo or Hi positions. You may hear slight
clicking sounds during cooking, indicating the control
is keeping the power level you set.
HOT SURFACE indicator light will glow when any
radiant element is turned on and will remain on until
the surface is cooled to approximately 150°F.
finish cooking. It will snap into the Off position.

Operating The Cooking Elements

Dual Surface Element
knob to the Small Burner settings.
knob to the Large Burner settings.
Tri-Ring Surface Element
center control knob clockwise to
desired setting. This will activate the entire heating area.
the center control knob clockwise to
the desired setting. This will activate the medium-size
heating area.
the center control knob clockwise to , stopping at the
desired setting. This will activate the smallest, inside
heating area.
12
Off when you
, stopping at the
, stopping at
49-80745 Rev. 2