Important Safety Information; Safety Alert Symbol - Greenlee CLM-1000 Manuel D'instructions

Important Safety Information

SAFETY ALERT
SYMBOL
This symbol is used to call your attention to hazards
or unsafe practices which could result in an injury
or property damage. The signal word, defined below,
indicates the severity of the hazard. The message
after the signal word provides information for pre-
venting or avoiding the hazard.
Immediate hazards which, if not avoided, WILL result
in severe injury or death.
Hazards which, if not avoided, COULD result in
severe injury or death.
Hazards or unsafe practices which, if not avoided,
MAY result in injury or property damage.
Read and understand this material
before operating or servicing this
equipment. Failure to understand how
to safely operate this tool could result
in an accident causing serious injury
or death.
Electric shock hazard:
Contact with live circuits could result
in severe injury or death.
CLM-1000 • CLM-1000E
Electric shock and fire hazard:
• Do not connect this unit to live voltage.
• Do not expose this unit to rain or moisture.
• Do not use the unit if it is wet or damaged.
• Using this unit near equipment that generates
electromagnetic interference can result in unstable or
inaccurate readings.
• Inspect the test leads or accessory before use. They
must be clean and dry, and the insulation must be in
good condition.
• Use this unit for the manufacturer's intended purpose
only, as described in this manual. Any other use can
impair the protection provided by the unit.
Failure to observe these warnings could result in severe
injury or death.
Electric shock hazard:
• Do not operate with the case open.
• Before opening the case, remove the test leads from
the circuit and shut off the unit.
Failure to observe these warnings could result in severe
injury or death.
Electric shock hazard:
• Do not attempt to repair this unit. It contains no user-
serviceable parts.
• Do not expose the unit to extremes in temperature or
high humidity. Refer to "Specifications."
Failure to observe these precautions may result in injury
and can damage the unit.
3