Fault History - SCANMASKIN 32 WORLD Serie Manuel

SCANMASKIN 32 WORLD SERIES
E37 Safe Stop
E038 Overload during low speed
E41 Communication Error
E81 Speed reference error
We strongly recommend that you first find the cause of the fault before clearing it.
Table 53 Error codes

5.6.3 Fault history

When a fault occurs, the inverter stores important performance data at the
moment of the fault. To access the data, use the monitor function (dxxx) and
select d081 details about the present fault. The previous 5 faults are stored in
d082 to d086. Each error shifts d081-d085 to d082-d086, and writes the new error
to d081.
The following Monitor Menu map shows how to access the error codes. When
fault(s) exist, you can review their details by first selecting the proper function:
D081 is the most recent, and D086 is the oldest.
www.scanmaskin.com
 Emergency is active
 Communication fails between motor drive and PLC
(DSP machines)
 The potentiometer on the control panel is dam-
aged
 Reset the Emergency stop
 Increase the speed
 Check the RJ45/Ethernet cable
 Inspect the potentiometer
 Replace if necessary
ENGLISH
99