Warranty - SCANMASKIN 32 WORLD Serie Manuel

7.

Warranty

This product from Scanmaskin Sweden AB comes with a 24-month warranty or 1500 hours, whichever comes first.
Scanmaskin Sweden AB warrants to the original end user, each new machine, new accessories and genuine replacement
parts against defects in material and workmanship under normal use and service. Warranty coverage shall begin on the
date of purchase by the original end user (as evidenced by your invoice from the factory or Authorized Dealer) or six (6)
months from the date the machine was shipped from the factory, whichever comes first. The warranty registration form
must be completed within 30 days of purchase visit
Our obligation under this warranty is limited to repair or replacement of the defective item at our factory or by an Autho-
rized Service Center according to the following conditions:
1. The warranty only applies to persons that have legal right to the equipment during the warranty period.
2. The manufacturer's undertaking is limited to the repair of defective parts or the replacement of these according
to the manufacturer's assessment. Costs and risks for transport as well as dismantling and reinstallation of the
product / products and other direct or indirect costs, associated with the repair in question, are not covered by
this warranty.
3. Periodic inspections, adjustments, maintenance work and changes are not covered by the warranty.
4. Scanmaskin is not liable for any damages to grinding discs, drive belts or other similar equipment.
5. The machine must be equipped with grinding tools approved by Scanmaskin Sweden AB
6. The warranty only applies to material and design deficiencies and does not apply in the following cases:
a. Damage caused through accidents, carelessness, changes, use of spare parts or grinding tools that are
not original components, or incorrect use and installation.
b. Damage caused by lightning, water, fire, vandalism, incorrect mains voltage, incorrect ventilation or other
causes that lie outside of the manufacturer's control.
7. Scanmaskin reserves the right to modify the design – or make improvements without obligation to change previ-
ously manufactured products.
8. Costs for repairs, carried out by an unauthorised workshop, will not be reimbursed by Scanmaskin. If such repairs
damage this product these are not cover by the warranty agreement.
130
www.scanmaskin.com/register-your-product/ to fill in the form.
www.scanmaskin.com