Instructions For Assembly To The Floor - asola 5641021000 Manuel D'utilisation Et De Service

K.

INSTRUCTIONS FOR ASSEMBLY TO THE FLOOR

Fig.14
The set of accessories for assembly to the floor consists of:
N.2 Supports each made up of 3 parts called A –B –C
N.2 Screws mm 8 x 30
N.2 Screws mm 8 x 60
N.2 Plugs mm 10 x 30 to be inserted into the hole in the floor.
Fig.15
Select the place of installation, keeping in mind the previous information, the size of the discs and
the availability of the electric power connection.
Make two holes in the floor with a distance of about 1000 mm between them.
Position discs A on the floor and over these part B, then fix to the floor using screws mm 8 x 60 and
plugs. Disc A doesn't need to be assembled. In this case, fix only part B to the floor.
If the discs are not assembled, leave a space of at least 50 mm between the appliance and the wall.
Fig.16
Insert part C taking care to direct the groove so that it takes the glass.
Insert the glass into the groove of supports C, taking care to make it enter gently all the way down.
Fig.17
Screw the allen-screws to the base of part C.
Fig.18
Next screw the allen-screws that block the glass taking care not to tighten them too much.
Fig.19
If not fixing to the floor, the holes in the floor are not needed ,disc A and part B must simply be fixed
together using the screws mm 8 x 30.
Fig.20
Now connect to the power and the appliance is in operation.
15