Instructions For Assembly To The Wall - asola 5641021000 Manuel D'utilisation Et De Service

J.

INSTRUCTIONS FOR ASSEMBLY TO THE WALL

Fig.1ig.1
The set of accessories for assembly to the wall include:
N.4 Supports made up of 3 parts called A –B –C
N.2 Supports made up of 2 parts called C –D
for the handle
N.1 Handle called E
N.4 Screws mm 4 x 45
N.4 Plugs mm 8 x 40 to be inserted in the holes in the wall.
Fig.2
Select the place of installation, taking into account all of the previous information and the availability
of the electric connection.
Using a spirit level mark the two points for the holes of the lower supports on the wall with a
distance 150 mm inferior to the base of the glass onto which it will be supported.
Make the holes on the wall trying to keep to the previously marked points.
Fig.3
Fix part A to the wall using the screw and plug keeping the eye horizontally and the screw in the
centre.
Fig.4
Fix part B over the previous part screwing all the way down.
Fig.5
Proceed in the same way with the second support, but before fixing completely regulate the height
using the eye to obtain the correct level.
Fig.6
Insert both parts C and fix the allen-screws of parts B to stop the glass accidentally leaving its
position in the next stage.
Direct the groove to receive the glass.
Fig.7
Gently insert the glass into the grooves of the two lower supports, taking care to position it in the
centre. Therefore, taking care insert the other complete supports on the upper side of the glass
trying to align them with the lower ones. Mark slightly on the wall the circumference of the two upper
supports against the wall, then remove the supports and the glass again.
Fig.8
Mark a cross in the middle of the two circles, so that the holes can be made more easily.
Fig.9
Fix upper parts A using screws and suitable plugs keeping the screw in the centre of the eye, then
screw parts B all the way down.
Gently insert the glass into the lower supports again, on the glass in correspondence to the upper B
parts insert the C parts and then insert these in the B parts fixed to the wall. If the two parts do not
coincide use the eye to regulate the height of the part fixed to the wall.
Fig.10
Once the upper supports have been assembled fix the allen-screws of the upper B parts too.10
Now gently tighten all the allen-screws of all the four C parts, this will block the glass inside the
grooves.
Fig.11
Now assemble the handle as required or desired.
Take the C parts and fix them using an allen- screw at the desired height on the glass.
Fig.12
Insert the two D parts on the ends of the handle and fix them with the inside allen-screw
Fig.13
Insert the two D parts into the corresponding C parts and tighten the allen-screws in part D.
Now connect to the power supply and the appliance is in operation.
14