Installation Rules; Laws For Disposal - asola 5641021000 Manuel D'utilisation Et De Service

H.

INSTALLATION RULES

Compare the values of the connection (voltage, power) shown on the data plate of the appliance
with those of the electric feeding system. The power required must be available from the system.
Individuate an area for installation with a free space of 20 cm on all of its perimeter.
Make sure the area round the appliance is not slippery, away from sources of heat and water, in
addition remove any objects or materials that can be deformed by the heat or which could go on
fire.
IT IS FORBIDDEN to place electrical appliances such as the one described near showers, the bath
tub, swimming pool etc.
The distance must be enough to stop anyone whether in the shower or the bath tub from reaching
the power supply socket or the on switch.
The appliance must be positioned at a distance of at least 30 cm from the normal glass of the
window frames, otherwise breakages due to thermal shock can occur.
If keeping at inferior distances, the glass must be single tempered safety glass.
For easy insertion and disinsertion of the plug, do not position the appliance directly under or in front
of the power supply socket.
The feeding cable must not be in contact with the surface of the appliance.
The electric feeding system must have a suitable and operative magnetothermic switch and
differential as well as a suitable earth circuit.
Usage, as well as the location and the plants where the appliance has been inserted, must respect
all the applicable safety rules.
Assembly of the appliance must always be carried out with the heated surface in the vertical
position, the appliance can not be installed to the ceiling or lying on the floor.
When assembling to the wall the appliance can be installed with the bigger side both vertically or
horizontally, but to use the handle the side equal to the length of the handle must be used a s a
base.
The supports must always be positioned on and under the appliance, never on its sides.
Assembly to the floor, must be carried out Exclusively with the bigger side positioned horizontally.
The connection box from where the cable starts must always be positioned in the lower part of the
appliance.
SUGGESTIONS
The unusual nature of a transparent element that heats up, can deceive anyone who has never
seen one before, therefore, avoid installation in places frequented by many people and which are
accessible to outsiders.
Avoid installation in points that obstacle the movement of people or animals or in front of doors, as
its transparency can make the appliance less visible.
Pay attention to cable positioning so that it is protected from tension or tears that are dangerous for
both people and animals as well as for the appliance itself.
As for all hot elements, this one too, failure to observe necessary precautions, can cause burns..
In any case pay particular attention to children.
Before making the holes on the walls or in the floor, make sure there are no systems underneath.
It is not possible to make any structural modifications or to modify the size of the appliance ( e.g.
make holes in it , shorten it ) as the glass will break.
I.

LAWS FOR DISPOSAL

The appliance must be disposed of appropriately and must NOT be thrown
out with the everyday rubbish. Disposal must be carried out by public or private
services specialized in this type of collection.
The appliance can easily be subdivided into GLASS, ELECTRIC AND ELECTRONIC
PARTS, METALS.
13