Remote Control; Remote Control Buttons; Using The Remote Control; Inserting Batteries Into The Remote Control - Arcam solo Manuel

remote
control
Solo iss4.id2

Remote control buttons

(Power)
2 – Switches Solo between stand-by and on.
Track/preset selection (0–9) – Press the number of the track or preset that you want to hear. To
select a track/preset greater than 9, press and hold the first digit of the track (e.g.
is shown in the bottom left corner of the display ('1–'), then press the second digit.
and
> ? – Used when listening to the radio to change the tuned frequency or the preset radio station.
INFO
– Changes the display mode for CD or radio.
MODE
– Some sources allow changes to the listening mode.
CD – Press the button to cycle through the repeat/shuffle modes for CD playback.
MODE
DAB/FM/AM – Press to switch between 'tune' and 'preset' mode. When in tune mode,
MODE
pressing or changes the tuned frequency (FM/AM) or the selected station (DAB); in preset
> ?
mode, the preset station is changed.
DISP
– Cycles the brightness of the front-panel display. There are several different brightness levels to
chose from, including switching the display off.
Source selection
– Press the appropriate button to select the audio source you would like to hear.
Cursor keys and OK
– When listening to music, the
and keys described above, with the
> ?
with the button, these keys also find use in navigating the configuration menu of Solo, described
OK
on pages 11 and 12.
Mute
– Press once to mute the speaker and pre-amp outputs of Solo. Press for a second time (or change
the volume) to unmute the unit.
MENU
– Pressing the button allows entry into the configuration menu of Solo. This is described
MENU
fully on pages 11 and 12. Press the
MENU
CD play-back commands
(Play) – press this button to start the play-back of a CD.
4
(Stop) – press to stop the play-back of a CD.
<
(Pause) – press to pause the play-back of a CD. Press again (or press play) to re-start play-back.
;
/ (Skip/Scan backwards) – press and release this button to skip backwards to the beginning of the
current/previous track. Press and hold the button to scan backwards.
0 (Skip/Scan forwards) – press and release this button of skip forwards to the beginning of the next
track. Press and hold the button to scan forwards.
1 (Open/Close) – press to open the CD tray; press again to close it.
10
) until the number
1
and keys work in the same way as the
B C
and keys being used to change the volume. Together
– +
button for a second time to leave the menu.
E10
26/4/05, 7:59 pm

Using the remote control

Please keep in mind the following when using
the remote control:
Ensure that there are no obstacles
<
between the remote control and the
remote sensor on Solo. The remote has
a range of about seven meters. (If the
remote sensor is obscured, the remote
control input jack on the rear panel is
available. Please contact your dealer for
further information.)
Remote operation may become unreliable
<
if strong sunlight or fluorescent light is
shining on the remote sensor of Solo.
Replace the batteries when you notice
<
a reduction in the operating range of the

remote control.

Inserting batteries into the
remote control
1. Open the battery compartment by
pressing the button on the back of the
remote control.
2. Insert two 'AAA' batteries into the battery
compartment, following the polarity
indications given inside the compartment
itself.
3. Push the battery cover back into position.