Before Initial Operation; Connecting; Handling Cds; Useful Information About Usb-Devices - Kenwood M-820DAB-W Manuel D'utilisation

Before initial operation

Unpacking
Carefully unpack the device and take care that all accessories are present:
Operating manual Remote control
Notes about reading the manual
Most functions can be controlled using the remote control.
Preparation of the remote control
• Insert the battery into the remote control, taking care that it is in the correct polarity (+ and -).
• The battery provided is intended for functional checking and can have a short service life.
• If the operating range of the remote control decreases, replace the old battery with a new one.
• If you expose the remote control sensor to direct sunlight or the light from high frequency
fluorescent lamps, this may lead to malfunctions. In such situations, you should set up the system
at another place to avoid such malfunctions.

Connecting

• Carefully unpack the device and take care that all accessories are present.
• Connect the left and right speaker with the relevant
(Speaker Out) port on the side of the device.
• Connect the mains plug firmly to an AC outlet.
DAB+ / FM antenna port
1. Connect the cable to the [ANTENNA FM 75Ω] jack.
2. Find a place where the best reception is achieved.
3. Fix the antenna in position.
• The antenna provided with the system is a simple dipole antenna. The use of a (commercially available)
outdoor antenna is recommended for stable signal reception.
To connect an outdoor antenna, first take off the indoor antenna.
• DAB+ reception cannot be guaranteed when receiving radio transmissions from the cable network.
6
FM/DAB antenna LR03/AAA 1.5 Volt Battery
First use
When you use the device for the first time, an automatic DAB+ station scan is started. Please wait un-
til this procedure has completely finished. For further information on this, please refer to the "Using
the DAB+ radio" section.

Handling CDs

Precautions when handling
Hold the CD in such a way that you are not touching the signal surface. (The side without printing is
the playing side)
Precautions regarding CDs
Only use CDs with the mark. Among other issues, a CD without this mark cannot be correctly
played back.

Useful information about USB-devices

Notes on using a USB device
This device is able to play back audio files saved on a flash memory or digital audio player if this
device has a USB port (these devices are referred to as USB devices in this document).
The following restrictions apply to the USB devices which can be used:
Usable USB devices
• USB devices which belong to the USB mass storage class.
• USB devices which have a maximal power consumption of max. 500mA.
• USB mass storage class : USB devices which the PC recognises as external memory without the need
for a special drive or special application software.
• Please consult your dealer if you are not sure if your USB device complies with the USB mass storage
class specifications.
• Use of a USB device which is not supported can lead to faulty playback or display of the audio file.
Even if you use a USB device which complies with the above named specifications, depending on the
type or condition of the USB device, audio file may not play back properly among other issues.
7