Artusi ACSO45X Mode D'emploi page 14

ERROR SIGNALS AND OVEN MALFUNCTIONS
ERROR NO. 1: door open error (attention to steam)
- this occurs when you open the door during steam cooking and there is probably steam coming out
- it is indicated by the lighting of the green indicator light (5), 2 flashes + a pause of 5 seconds + 2
flashes + pause, etc. The buzzer will sound in sync with the light for a maximum of 180 seconds.
GB
Then, only the signal light will continue.
- it is reset when the door is closed
ERROR NO. 2: boiler temperature error
- it occurs when water carafe is not in its seat and/or the pitcher has no water and/or the o-ring is
not present on the tube of the carafe
- it is indicated by the lighting of the green light (5) and 3 consecutive beeps + a pause of 5 seconds
+ 3 beeps, etc., for a maximum of 180 seconds. Then, only the signal light will continue.
- when the door is opened, it becomes error 1
ERROR NO. 3: boiler pump error:
- it occurs after no. 4 alarms of type 2 error or if the boiler temperature and higher than 220 °C
- it is indicated by the lighting of the green light (5) with cycles of 1 flash in sync with the indicator
light for a maximum of 180 seconds
- when the door is opened, it becomes error 1
ERROR NO. 4: probes/potentiometers:
- this occurs because of a problem with the probes or potentiometers
- it is indicated by the lighting of the green light (5) with cycles of 1 flash and a continuous fast beep
- it cannot be reset until the fault is fixed
- CONTACT SUPPORT AS SOON AS POSSIBLE. DISCONNECT THE OVEN FROM THE POWER
SUPPLY
ERROR NO. 5: both grill and steam knobs on
- this occurs if both the grill and steam commands are on
- it is indicated by a beep for 5 seconds + a pause of 10 seconds + plus a beep for 5 seconds, etc.,
until it is reset.
- it is reset by turning one of the controls (grill or steam) to 0
ERROR NO. 6: Blackout
- this occurs in the case of a power failure during cooking
- it is indicated by the lighting of the green lights and a continuous beep
- it is reset to 0 by turning the active command to 0 (turning cooking off) and then turning it on again
30