Geberit Aquaclean Mera Comfort WC Instructions De Montage page 48

EN
Adjusting basic settings to
customer's wishes
Comfort model
Prerequisite
• Function test of the device was performed
successfully
• Testing of the remote control was performed
successfully
The basic settings of the device are set
from the rear of the remote control.
The following steps are shown in shortened
form. See user manual for an overview of
the complete menu.
1
Launch [Basic settings] main menu via the
<left> or <right> arrow key.
• Select submenus with the <up> and
<down> arrow keys.
• Configure settings with the <left> and
<right> arrow keys.
2
Launch the [Select language] menu. Set the
menu language.
3
Launch the [Water hardness] menu. Set the
hardness value in accordance with the local
water hardness.
Table 1: Water hardness
Range °fH
≤15
soft
medium 15–25
hard >25
Set to [hard] if you do not know the local
water hardness.
48
Basic settings
Select language
English
°dH °eH
≤8 ≤11
8–14 11–18
>14 >18
Water hardness
hard
4
Launch the [Orient. light colour] menu. Set
colour.
Orient. light colour
white
If Geberit Monolith Plus is installed, select
the same colour as the orientation light.
5
Launch the [Orient. light bright.] menu. Set
brightness.
Orient. light bright.
6
Launch the [Orientation light] menu.
Configure switch-on behaviour.
Orientation light
on approach
7
Launch the [Lid lifter] menu. Set the sensor
range.
WC lid detect. range
Result
Reliably detects the user.
The sensor must be configured so that the
WC lid does not lift up unintentionally!
8
Launch the [Basic settings] menu.
Basic settings
Result
The settings are saved.
The device is installed correctly.
B1238-002 © 01-2016
966.729.00.0 (03)