Appendix; Troubleshooting - ABUS Security-Center TV7218 Instructions D'installation

Appendix

A. Troubleshooting
LED status display
Following switch-on, the security network camera runs a diagnostic self-test to detect potential hardware
faults. The following table lists the general LED patterns. In the event of a serious fault or error, the LED
flashes differently from the patterns listed below.
Condition
During the self-test following switch-on:
No Ethernet signal found:
Before the network is set up:
After the network is set up:
Other hardware faults:
Resetting and restoring
In the opening next to the I/O terminal block is a button. Press this button to reset the system or restore the
factory parameter settings. Sometimes the normal system status can be restored by a reset. If you have
further problems following a reset, restore the factory parameter settings and reinstall and reconfigure the
system.
RESET:
Press the reset button with a pointed object.
RESTORE:
1. Press the button continuously with a pointed object.
2. Wait until the self-test runs a second time.
3. Release the reset button after both LEDs shut off.
LED colour
Blinking in interchanged Green and Red
Red LED is constantly ON and Green LED is OFF.
Red LED is constantly ON and Green LED is OFF
Red LED is constantly ON and Green LED is
blinking every 0.5 seconds
Other patterns
If the factory parameter settings are restored, all the
previous settings are deleted. The system can be reset or
restored.
40