Battery Installation / Optional Accessory Charging Instructions - Spyder ELECTRA WITH EYE Manuel De L'utilisateur

BATTERY INSTALLATION
SCR002
SCR002
Part Names and Numbers described in this section:
Dual Texture Grip Panel (#GRP005)
M4 x 8 Screw (A) (#SCR002)
Battery Harness (#WRH002)
BATTERY INSTALLATION
Kingman Group recommends using a Spyder 9.6volt NiMH Rechargeable Battery as a power source for optimum
performance and will provide a superior shot count of around 5000 to 6000 rounds. (Spyder Battery and Charger
Sold Separately)
NOTE: This marker is compatible with the use of 9volt Alkaline batteries. Use only premium brand Alkaline batteries
for best performance. (Battery Not Included)
Shot counts will vary depending on the type of 9volt Alkaline battery used (2300 to 3200), choosing a premium
brand battery will give the best results.
IMPORTANT: Performance will vary depending on the mode used and rate of fire achieved.
STEP 1 Remove the three
the spare parts kit.
STEP 2 Attach the battery to the battery harness.
STEP 3 Re-tighten the three
HELPFUL TIP: Please note how the parts are removed for easy reassembly.
5
GRP005
M4x8 Screws from the Right side grip panel.
M4x8 Screws.
WRH002
NOTE: Allen wrench provided in