A Jammed Paintball - Spyder ELECTRA WITH EYE Manuel De L'utilisateur

REASSEMBLY REAR INTERNALS
STEP 1 Reinsert the Striker Bolt with Striker O-ring facing toward the front of the marker with the flat spot of the
Striker Bolt facing down. NOTE:
pressure behind the Bolt and at the same time pull on the Trigger. Repeat this process until the Bolt is fully inserted.
NOTE: The hole on the Striker Bolt should be facing upright when looking thru the Receiver.
above display the Delrin Bolt "connected" to and "disconnected" from the Striker Bolt.
STEP 2 Insert the Striker Buffer flush with the receiver and place the Striker Spring thru the Striker Buffer.
STEP 3 Tighten firmly the Striker Plug w / Velocity Adjuster & Spring Guide to the rear of the Receiver.
STEP 4 Insert the Delrin Bolt thru the rear of the Receiver with the Top Cocking Pin. Press downward on the Top
Cocking Pin to gain entry with the Striker Bolt.
Pin will not fasten correctly.
WARNING: Before / after use of the marker, make sure to fasten all screws. Screws may become loose due to
vibration. Loose screws can be dangerous and cause injury.
To assure that the marker is assembled properly, follow the schematic drawing or position parts in order during
disassembly. Parts assembled backwards or improper parts installed will / can cause the marker to malfunction.
A JAMMED PAINTBALL IN THE BREACH
In the event of a paintball break and the Delrin Bolt jams, follow these steps to help un-jam the marker. The markers
breach is located where the barrel starts to thread in the receiver and underneath the markers feed neck. Before
attempting to un-jam the Delrin Bolt you should always have your Goggles or Safety Glasses on. Make sure the
marker is in the SAFE / OFF position before attempting to un-jam the Delrin Bolt. Remove the CO2 / Compressed
Air Tank before attempting to un-jam the marker. Remove all paintballs and the loader from the feed neck. Have the
barrel removed from the receiver to allow the paintball (s) to exit. With enough force on the Cocking Knob, pull back
to release the Delrin Bolt from the jammed position. Another method is to use a "Straight Shot Squeegee" or the end
of a wood dowel rod; push against the face of the Delrin Bolt with enough force to release the jammed Bolt. Always
clean the paint from the breach and barrel to enhance the performance of your marker.
IMPORTANT: Never look down the barrel of the marker when loaded or unloaded. Remove the attached CO2 /
Compressed Air Tank before attempting to un-jam the Delrin Bolt.
NOTE: Never use a metal rod or screwdriver as a tool to push on the Delrin Bolt, anything metal will scratch and
damage the inside of the marker.
CONNECTED
Having the Power Switch ON will ease reentry of the Striker Bolt. Apply thumb
NOTE: If the Striker Bolt hole is not aligned upright, the Top Cocking
English
DISCONNECTED
NOTE: The images
12