Operation Guide / Start Up - Spyder ELECTRA WITH EYE Manuel De L'utilisateur

OPERATION GUIDE / START UP

WARNING:
Always keep the marker powered OFF or on SAFE until you are ready to fire.
1. Always attach a barrel blocking device over the tip of the barrel for safety precautions when the marker is not in use.
2. Install and charge the battery see pages (See Battery Installation)
3. Attach a CO2 / Compressed Air Tank to the C/A On/Off Adapter.
Compressed Air Tank filled before attaching to the marker. Hand tighten the tank clockwise in the markers C/A
On/Off adapter until it is snug. If an air leak occurs between the tank and the C/A On/Off adapter, replace the
urethane O-ring. NOTE:
Tank. IMPORTANT: You should never need to use any hand tool to attach a CO2 / Compressed Air Tank to the
C/A On/Off adapter.
4. Attach an electronic paintball loader and elbow to the markers Feed Neck. Only use .68 caliber paintballs
through the electronic loader.
loader to reach optimum performance.
5. Turn Power On for the electronic trigger frame (See LEAP™ Circuit Board w/CAMD Settings).
6. Cocking the marker. Pull the Top Cocking Knob rearward until the Delrin Bolt latches.
let go of the Top Cocking Knob before it latches, your marker may fire.
7. Remove the barrel blocking device.
trigger will fire a paintball.
8. Performing a velocity (fps) check. Turning the velocity adjuster & spring guide clockwise will increase the
velocity (fps) while turning counter-clockwise will decrease the velocity (fps).
to be used in a paintball facility with the proper paintball protection.
a chronograph to ensure that the maker's velocity is under 300 (fps).
9. When finished playing, remove all paintballs from the paintball loader before detaching from the markers feed
neck. CAUTION: There may be paintballs in the marker's breach; take a couple of shots in a safe direction to
make sure the barrel and receiver are empty.
10. Place the barrel blocking device over the barrel tip. This will help avoid any accidental discharge.
11. Kingman recommends having the marker in the "SAFE or OFF" position after use.
12. Unscrew the CO2 / Compressed Air Tank from the marker's C/A adapter. Firmly hand loosen the tank counter-
clockwise will detach it from the marker's C/A adapter.
adapters bleed hole when removing the tank. This can run the risk of getting skin burn from the releasing of
the GAS. IMPORTANT:
13. Store the marker in a paintball bag or in a safe place.
to fasten all screws. Screws can become loose due to vibration. Loose screws can be dangerous and cause
injury. HELPFUL TIP:
storing the marker for an extended period of time. Add a few drops of paintball gun oil on the Striker O-ring
(see Disassemble / Reassemble). Before storing the marker, make sure the marker is in the un-cocked position.
This will help the main spring maintain its tension.
IMPORTANT
• Firing velocity may vary according to altitude and climate conditions.
• Before using your marker in play, you must always first perform a "SAFE VELOCITY TEST". This can only be
accomplished by using a testing device called a "Velocity Chronograph" and can be performed at a paintball
dealership or local playing field.
feet per second (fps). Paintball markers are not intended to shoot any person less than 25 feet away without
EYE/FACE PROTECTION.
• This paintball marker may have excess gas after the removal of the CO2 / Compressed Air Tank. Please
remove all paintballs and discharge the remaining gas safely.
• Never store a CO2 / Compressed Air Tank attached on the marker while not supervised.
O-rings in the markers parts kit are not supplied to attach with a CO2 / Compressed Air
NOTE: Kingman recommends that you use a force feed / high speed electronic
CAUTION: With the power switch turned ON the marker is
IMPORTANT: Only test your marker in a safe direction or in a designated playing field.
You should never need to use any hand tool to detach a CO2 / Compressed Air Tank.
It's a good practice to lubricate your marker before and after each use, especially when
NOTE: This product is intended to be used at a velocity no greater than 300
HELPFUL TIP:
NOTE:
IMPORTANT:
CAUTION: Never expose any skin underneath the C/A
WARNING: Before / after use of the marker, make sure
English
Make sure to have the CO2 /
CAUTION: Should you
LIVE. Pulling the
Your marker is intended
Kingman recommends using
2