Troubleshooting / Air Leaks - Spyder ELECTRA WITH EYE Manuel De L'utilisateur

TROUBLESHOOTING
ONE OR MORE OF THE FOLLOWING MAY CAUSE RECOCKING RELATED ISSUES:
• Need lubrication on the following O-ring (#ORG001) (see Disassemble / Reassemble).
• The pressure in the tank is too low and possibly needs to be refilled.
• Striker O-ring (#ORG001) is damaged or missing. Replace with a new Kingman approved Striker O-ring.
NOTE: The Striker O-ring can not be substituted with a black or urethane bottle o-ring.
• Dirt or broken paint shell fragments in the receiver can cause the marker to have recocking issues. Using a
squeegee thru the upper portion of the receiver will remove most of the dirt or broken shell fragments. Should
this issue continue, (see Disassemble / Reassemble) remove the markers internals for complete cleaning.
• Using low quality paintballs can cause the marker to experience recocking issues because of the shape of
the paintballs.
Paintballs can take a different shape over time, so it would be wise to size the paintball with your barrel.
ELECTRONIC TRIGGER FRAME TROUBLESHOOTING
• If your marker is not shooting it may be due to one of the following problems:
• Battery may need to be recharged.
• The Battery Wire Harness is not properly attached to the circuit board.
• The Coil Set Harness is not properly attached to the circuit board.
• The Touch Switch Harness is not properly attached to the circuit board.
any dirt or paint, Kingman recommends using an aerosol can of air. Apply the can of air directly at the
components that need cleaning.
AIR LEAKS
IMPORTANT: Always remove the air tank and paintballsbefore any disassembly of the marker.
• Air leaking from the Front Plug means the O-ring (#ORG002) will need to be oiled or replaced.
• Air leaking from the Vertical Adapter means the O-ring (#ORG023) will need to be oiled or replaced.
• Air leaking down the barrel is usually caused by a worn or damaged cup seal (#ITP012). (see Cup Seal
Removal) should the cup seal need to be exchanged.
• Never remove Valve Body (#ITP018) unless specific repairs are needed.
• A nick or scratch on the lip of the Valve Body can cause an internal air leak (see Cup Seal Removal). The Valve
Body may need to be replaced.
• Air leaking thru the Receiver and out of the Trigger Frame would indicate the Valve Body O-rings (#ORG002)
will need to be replaced.
• If air is leaking thru the opposite end of the hose fittings, please check the following:
• The female end of the hose must have a plastic washer (#HSF004) installed inside the hose collar and be
tightened properly.
IMPORTANT: The hose line supplied has metric female ends. This will not install into American 1/8" (NPT) threaded
fittings. If installed incorrectly, it is possible to damage the attachment fittings and hose line.
HELPFUL TIP: To assure marker is assembled properly, follow the schematic drawing or position parts in order
during disassembly. Parts assembled backwards or improper parts installed will / can cause the marker to
malfunction.
15
HELPFUL TIP: Paintballs have a shelf life and can become too fragile for use. HELPFUL TIP:
NOTE: If the Markers Electronics have