General Information - Jaga BRIZA 22 HYBRID Instructions D'installation

GENERAL INFORMATION

Device description:
Jaga Briza 22 are fan coils for the treatment of air in indoor environments.
The units comply with the following Directives:
- 2006/42/EC Machinery Directive
- low voltage Directive 2006/95/EC
- electromagnetic compatibility Directive 2004/108/EC
- regulation n.327/2011/UE implementing Directive 2009/125/EC ERP
Declared conditions of use:
The unit is not designed to be installed in wet areas (IEC EN 60335-2-40).
DANGER !
- the unit is only to be installed in domestic or similar environments.
- it is prohibited to insert objects through the air inlet and outlet vents.
IMPORTANT !
- -the unit will function correctly only if the instructions for use are strictly followed, if the
specified clearances are complied with during installation, as well as the use restrictions
indicated in this manual.- an installation that does not include the recommended free spaces,
resulting in difficulty in maintenance and reduced performance.
- pay the utmost attention to the signs and symbols located on the appliance.
Identification of the unit:
The units are equipped with a label sharing the serial number plate on the right side of the unit (on
the left if the connections are on the right side of the unit).
Functioning limits:
Installation that does not meet the operating limits specified relieves Jaga N.V. from liability con-
cerning damage to objects and persons.
- power supply voltage: 230 V - 1 ph - 50 hz
- maximum water inlet temperature: 90°C.
- maximum exchanger pressure: 20 bar.
- power supply voltage: 230 V ±10 %.
Information regarding unintended use:
The unit has been designed and constructed solely and exclusively to function as an air treatment
terminal unit with ducting or panelling; any other use is strictly forbidden. Installing the unit is an
explosive environment is prohibited.
Decommissioning:
When the unit is not used for long periods of time, it must be disconnected from the mains by
opening the mains switch of the system, set in place by the installer.
If the unit is not used during the winter period, the water contained in the system may freeze. All
the water in the circuit must be drained on time. Alternatively, a suitable quantity of anti-freeze
liquid should be mixed with the water.
Restart after prolonged shutdown:
Before starting up again:
- clean or replace the air filter.
- clean the exchanger.
- clean or unclog the drain of the condensate tray.
- bleed the water system.
- it is advisable to run the unit at maximum speed for serveral hours.
74 BRIZA 22 HYBRID BUILT-IN installation instructions
|
jaga