Jaga BRIZA 22 HYBRID Instructions D'installation page 81

02
The type of wall determines what type of screw or plug should be used.
For installation on drywall: make sure that the mounting holes line up with supporting studs.
Hydraulic connection
It is very important for the water connections to be installed with care by qualified personnel.
03
Connect the unit to the hydraulic system with the indicated inlet/outlet connections. Make sure the
connections are air tight with a sealant.
All heat exchangers (including the additional one) are equipped with an air vent near the top con-
nection and a water drain near the lower connection.
04
3 cm/m
Coils can be partially drained; it is recommended to bleed air inside the coil to be drained
completely.
Setting up the condensate drain:
The condensation drainage system must be set up with an adequate inclination to make sure the
water drains properly.
Wall mounting
Wall mounting
jaga
3 cm/m
|
BRIZA 22 HYBRID BUILT-IN installation instructions 81
EN
Ceiling mounting
Ceiling mounting