Important Advice - DOMENA Dual Force 45 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1

IMPORTANT ADVICE

When using the machine, the following elementary precautions should be taken :
– Before connecting your iron to the mains, make sure that your mains voltage corresponds to the voltage
indicated on the rating plate.
– This machine should only be used for its intended purpose: ironing and smoothing
– When unplugging the machine, pull the plug, not the cable.
– Make sure that the power cable does not touch any hot surfaces.
– Do not use the iron if it is damaged, if it leaks, or if the power cable is damaged.To avoid any risk of electrocution,
do not dismantle your iron. Take it to your nearest After Sales Service dealer for servicing or repair.
– Great care must be taken when ironing in the presence of children. Do not leave iron unattended whilst
switched on.
– Never direct the jet of steam towards yourself or anyone.The steam may contain droplets of hot water that might
cause some burns.
– To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
– If an extension lead is absolutely necessary, a 10 amp. cord should be used. Make sure that you cannot
trip over or unplug the extension lead. It must be equipped with an earth connection.
– Use a mains supply which has an earth connection, for your own safety.
– Take care to place the iron on its rest after each use.
– The iron can be set down vertically on its heel or horizontally on its soleplate, in which case make sure to
place it on the iron rest included or other surface suitable for the high temperature of the soleplate.
– After ironing, let the iron cool down. You can then store it flat or on its heel.
– Never immerse the machine in water or other liquids, even partially.
– If the mains lead is damaged, have it replaced by the manufacturer, after-sales service or by a similarly
qualified person in order to avoid any potential danger.
– Never use the steam trigger when the water tank is empty.
– Keep the filling cap closed during use. Always unplug the iron before filling the water tank.
– If you notice steam leaking from anywhere other than the steam vents on the soleplate, unplug your iron
immediately and take it to the nearest approved after-sales centre.
– For any repair, take your machine to a registered after-sales service centre, to ensure that the repair will
comply with the manufacturer's standards and quality requirements.
– Any repair carried out by an unauthorized person will invalidate the warranty.
The manufacturer reserves the right to makes changes and alterations to the product without prior notice.
The appliance which you have just purchased complies with the terms of European Directive 73/23 EEC relating to safety and low
voltage, and with Directive CEM 89/336/EEC regarding electromagnetic compatibily as amended by 93/68/EEC.
Wiring instructions
WARNING - THIS APPLIANCE MUST BE EARTHED
The wires in the mains lead are coloured in accordance with the following code :
BLUE : NEUTRAL
CONNECTING INSTRUCTIONS
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug proceed as follows : the core which is coloured
BROWN must be connected to the terminal which is marked with the letter L or coloured RED.
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.
The wire which is coloured GREEN or GREEN and YELLOW must be connected with the terminal which is marked with the
letter E or the earth symbol
IF THE TERMINALS OF YOUR 3 PIN PLUG ARE UNMARKED OR IF YOUR INSTALLATION IS FITTED WITH A 2 PIN
PLUG, CONSULT A QUALIFIED ELECTRICIAN. IF A 13 AMP. PLUG IS FITTED, FIT A 13 AMP. FUSE.
IMPORTANT SAFETY DEVICE
The mains lead supplied with this equipment is fitted with a 13 amp plug which is fitted with a 13 amp fuse. If you need to
examine or change the fuse, a BS 1362 13 amp. fuse must be fitted, and the fuse cover must be replaced. If you lose or
damage the fuse cover, the plug MUST NOT be used until a replacement is obtained from your local After Sales Service
Centre.
WARNING : If you cut off the moulded plug, throw it away immediately. This plug is not rewireable and will cause electric
shock if it were plugged into an electrical socket.
IMPORTANT FOR U.K. ONLY
BROWN : LIVE
GREEN AND YELLOW : EARTH
or coloured GREEN or GREEN and YELLOW.
ENGLISH
E
L
N
9

Publicité

Table des Matières
loading

Table des Matières