Collomix CMG 1700 Mode D'emploi Original page 11

Device-specific safety instructions
WARNING:
Hazard-free working conditions can only be en-
sured if the operating manual and the safety in-
structions have been read in their entirety, and if
all instructions are strictly adhered to. The ma-
chine must only be operated by personnel famil-
iar with the operating manual and the applicable
health and safety regulations.
Store all safety notes and instructions in a safe
location for future reference.
The additionally attached "General Safety In-
structions" must be strictly complied with.
This power tool is to be used for the purpose
of grinding. Comply with all safety notes, in-
supplied with the device. Non-compliance
This power tool is not suitable for: sand paper
grinding, tasks involving wire brushes, polish-
power tool is not intended may result in haz-
ards and injury.
Do not use accessory that has not been specif-
ically designed for this power tool or has not
been recommended by the manufacturer. The
fact that you may be able to mount accessory
to the power tool does not mean that its safe
use is guaranteed.
insert must be at least as high as the max.
speed stated on the power tool. Any accessory
that rotates at a higher speed that permissi-
The outer diameter of the tool insert must
match the measurements provided for your
power tool. Incorrectly dimensioned tool in-
serts can not be appropriately shielded or con-
trolled.
actly onto the grinding spindle of your power
tool.
onto the grinding spindle of your power tool
will rotate unevenly, will vibrate severely, and
may result in a loss of control over the power
tool.
Never use damaged tool inserts. Check the
diamond cup wheel for cracks, wear or de-
power tool or tool insert must be checked for
any damage; never work with damaged tools.
Once you have checked and inserted the tool
insert, ensure that you and other personnel
in the immediate vicinity remains outside the
it at max. speed for one minute. Damaged or
this test phase.
gloves or a special apron to protect you from
levels may result in a loss of hearing.
Ensure that other personnel in the vicinity
remain at a safe distance to your work area.
Any personnel entering the work area must
be wearing relevant PPE. Workpiece debris or
outside the immediate work area.
Only touch the power tool at its insulated grips
when carrying out tasks in which the tool in-
serts could compromise hidden power lines
or the power tool's own power cable. Contact
with a live line will conduct electricity through
the metal parts of the power tool and may re-
inserts. Should you lose control of the power
tool, then the power cable could be cut or
snared, and your hand or arm could be drawn
with the storage surface, which could result in
a loss of control over the power tool.
Your clothing could accidentally be snared by
injury.
Clean the air vents of your power tool regular-
-
ly. The motor blower draws dust into the hous-
cause electrical hazards.
Do not operate the power tool in close proxim-
Do not use tool inserts that require liquid cool-
ant. The use of water or other liquid coolants
Grinding disks that are not designed for use
Rev. 3 / 11
Prolonged exposure to extreme noise
Flying sparks could
-
-
-
he