Using The Gliding Rack - Samsung NX60T8751SS Manuel D'utilisation

Before using the racks
The oven has two racks.
Each rack has stops that need to be placed correctly on the supports. These stops
will keep the rack from coming completely out.
REMOVING THE RACKS
1. Pull the rack straight out until it stops.
2. Lift up the front of the rack, and then pull it out.
REPLACING THE RACKS
1. Place the end of the rack on the support.
2. Tilt the front end up and push the rack in.
NX60T8751SS_AA_DG68-01219A-00_EN.indd 29
CAUTION
• Do not cover a rack with aluminum foil or
place aluminum foil on the oven bottom.
This will hamper heat circulation, resulting
in poor baking, and may damage the oven
bottom.
• Arrange the oven racks only when the
oven is cool.

Using the gliding rack

The fully extendable Gliding Rack makes food preparation easier, especially when
you are preparing heavier dishes. The Gliding Rack has 2 glide tracks that allow
you to extend the rack well out of the oven without touching the sides of the oven
walls.
Installing the Gliding rack
• With the Gliding rack in the "Closed"
Rack
Guides
• When using the Gliding Rack in the oven,
position and the oven off, carefully insert
the Gliding Rack between the guides until
the rack reaches the back.
be sure to pull on the handle of the rack
only to slide it in and out. If you grasp
the frame while using the rack, the entire
Gliding Rack will be removed. Make sure
you use oven mitts when handling the
Gliding Rack during cooking.
English 29
3/26/2020 8:39:33 PM