Samsung NX60T8751SS Manuel D'utilisation page 52

Maintenance
How to reinstall the door
You can reinstall the upper door the same way you reinstall the full door.
1. Firmly grasp both sides of the door at the top.
2. With the door at the same angle as the removal position, slide the indentation
of the hinge arm into the bottom edge of the hinge slot. The notch in the hinge
arm must be fully inserted into the bottom of the slot.
Bottom edge of slot
Hinge arm
Indentation
3. Open the door fully. If the door will not open fully, the indentation is not
inserted correctly in the bottom edge of the slot.
4. Push the hinge locks up against the front frame of the oven cavity into the
locked position.
5. Close the oven door.
52 English
NX60T8751SS_AA_DG68-01219A-00_EN.indd 52
Hinge lock
Unlocked position Locked position
How to remove and reinstall the Storage drawer
Storage drawer
1. Slide open the drawer until it stops.
2. Locate the roller guide clips on either
3. Clean the drawer in warm, soapy water
4. Put the drawer in the roller guides on
side. Using both hands, pull down the left
clip while lifting the right clip, and then
remove the drawer.
using a cloth or soft brush. Then, rinse
and dry it thoroughly.
either side, and then snap the clips into
place.
3/26/2020 8:39:47 PM