Leister BITUMAT B2 Instructions D'utilisation page 20

Operating preparation
• Before putting into operation, check power supply cord (1) and connector as well as extension cable for electrical
and mechanical damage.
• Move lower guide bar (15) into the required position using clamping screw, lower guide bar (17) and
upper guide bar (33) using clamping lever, upper guide bar (16).
• Clip strain relief of power supply cord (1) in holder (18).
• Check the basic setting of the welding nozzle (7).
– The welding nozzle (7) must lie flat on the lower membrane liners (see Detail A).
– The distance between the centre of the drive roller (13) and the air outlet of the welding nozzle (7)
should be 80 mm (see Detail B). Otherwise the hot air blower (8) must be set with the scale for tool
adjustment (12) by loosening the screws (24).
– The welding nozzle (7) should be set parallel with the drive roller (13
• Transport configuration
– Swivel the guide roller (19) upwards
– Extend the hot air blower (8) by pulling the locking lever (10) and swivelling it up until it locks in place.
• Set the guide roller (19) to the required overlap using the guide roller adjusting screw (20).
• The distance between Guide roller (19) and Drive roller (13) is 5 mm (Detail C).
Detail A
Detail B
7
Detail C
13
20
7
13
20
19
33
18
1
17
19
10
8
20
16
15
12
13
7
24