Juniper Networks NETSCREEN-5GT ADSL Guide De L'utilisateur page 34

C
ONSOLE AND
The following table lists the RJ-45 connector definitions. To employ a standard UART
port, both the console and the modem ports use this configuration.
RJ-45 Signal
1 Request To Send
2 Data Terminal Ready
3 Transmitted Data
4, 5 Signal Ground
6 Received Data
7 Not Connected
8 Clear To Send
The following shows the pin locations of the RJ-45 connector port on the NetScreen device:
Note: If you use the Console cable that is provided with the NetScreen device to connect to
a modem, you need to obtain and install a null modem adapter on the modem connector.
30
M A
ODEM DAPTER
Abbreviation
RTS
DTR
TD
SGND
RD
CTS
8 7 6 5 4 3 2 1
Appendix A Specifications
C
ONNECTIONS
DCE
In
In
In
N/A
Out
Out
User's Guide